Users Guide

Layer 3 Routing Commands 1637
Example
console(config-if-vlan3)#ipv6 pim dr-priority 10
ipv6 pim hello-interval
Use the ipv6 pim hello-interval command to configure the PIM-SM Hello
Interval for the specified interface. Use the no form of this command to set
the hello interval to the default.
Syntax
ipv6 pim hello-interval interval
no ipv6 pim hello-interval
• interval — The hello interval (Range: 0–18000 seconds).
Default Configuration
The default hello interval is 30 seconds.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
Setting the hello interval to 0 disables sending on PIM Hellos.
Example
console(config-if-vlan3)#ipv6 pim hello-interval 45
ipv6 pim join-prune-interval
Use the ipv6 pim join-prune-interval command to configure the interface
join/prune interval for the PIM-SM router. Use the no form of this command
to set the join/prune interval to the default.
Syntax
ipv6 pim join-prune-interval interval
no ipv6 pim join-prune-interval
• interval — The join/prune interval (Range: 0–18000 seconds).