Users Guide

Layer 3 Routing Commands 1790
• seconds — OSPF transmit delay for the specified interface. In addition, it
sets the estimated number of seconds it takes to transmit a link state
update packet over this interface. (Range: 1 to 3600 seconds)
Default Configuration
No default value.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF Transmit Delay at 100 seconds for
VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf transmit-delay 100
ipv6 router ospf
Use the ipv6 router ospf command to enable OSPFv3 and enter Router
OSPFv3 Configuration mode. Use the no form of the command to disable
OSPFv3 and remove the OSPFv3 interface and global configuration.
Syntax
ipv6 router ospf
no ipv6 router ospf
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.