Users Guide

Layer 3 Routing Commands 1825
no set ipv6 precedence 0-7
Default Configuration
This command has no default configuration.
Command Mode
Route Map mode.
User Guidelines
This command rewrites the precedence value in the packet header. It does not
alter the treatment of the packet QoS in the local switch. The precedence
value set may be used by other QoS services in the network, such as weighted
fair queuing (WFQ) or weighted random early detection (WRED).
The set ipv6 precedence clause may be combined with set ipv6 next-hop or
set ipv6 default next-hop clause in a route map.
Command History
Command introduced in version 6.6 firmware.
show ipv6 policy
Use this command to show which IPv6 policy route maps are configured on
an interface.
Parameter Description
0 Sets the routine precedence.
1 Sets the priority precedence.
2 Sets the immediate precedence.
3 Sets the Flash precedence.
4 Sets the Flash override precedence.
5 Sets the critical precedence.
6 Sets the internetwork control precedence.
7 Sets the network control precedence.