Users Guide

Layer 3 Routing Commands 1838
User Guidelines
The access list has an implicit deny all, so it is advisable to have a permit
statement somewhere on the access list.
The BGP parameter is only available in firmware versions enabled for BGP.
Example
The following example elects access list ACL40 to filter routes received from
the source protocol.
console(config-router)#distribute-list ACL40 out static
enable
Use the enable command in Router RIP Configuration mode to reset the
default administrative mode of RIP in the router (active). Use the no form of
the command to disable the administrative mode for RIP.
Syntax
enable
no enable
Default Configuration
Enabled is the default configuration.
Command Mode
Router RIP Configuration mode.
User Guidelines
This command has no user guidelines.
Example
console(config-router)#enable