Users Guide

Layer 3 Routing Commands 1885
fhrp version vrrp v3
Use the fhrp version vrrp v3 command to enable Virtual Router Redundancy
Protocol version 3 (VRRPv3) configuration on the switch. To disable the
VRRPv3 and possibly enable VRRPv2, use the no form of this command.
Syntax
fhrp version vrrp v3
no fhrp version vrrp v3
Default Configuration
VRRPv3 is not enabled by default.
Command Mode
Global Configuration mode
User Guidelines
When VRRPv3 is enabled, VRRP version 2 is disabled, the VRRP operational
data is reset and VRRPv3 configuration is applied.
When VRRPv3 is in use, VRRP version 2 is disabled. If the no fhrp version
vrrp v3 command is issued, VRRPv3 is disabled, VRRPv2 is enabled if
configured, the VRRP operational data is reset and VRRPv2 configuration is
applied.
VRRPv2 and VRRPv3 are not compatible. Do not use both VRRPv2 and
VRRPv3 in a network.
Command History
Command introduced in version 6.6 firmware.
vrrp
Use the vrrp command to create a Virtual Router Redundancy Protocol
version 3 (VRRPv3) group and enter VRRPv3 Group Configuration mode. To
remove the VRRPv3 group, use the no form of this command.