Users Guide

Layer 3 Routing Commands 1895
console(config-if-vrrp)#track interface vlan 10
track ip route
Use the track ip route command to configure tracking of the IP route for the
device within a Virtual Router Redundancy Protocol (VRRPv3) group. To
disable object tracking, use the no form of this command.
Syntax
track ip route ip-address/prefix-len [decrement number]
no track ip route ip-address/prefix-len [decrement number]
• ip-address/prefix-len—Prefix and prefix length of the route to be tracked.
• number—(Optional) Amount by which the priority is decremented. The
range is 1–254.
Default Configuration
Tracking is not enabled by default.
Command Mode
VRRPv3 Group Configuration mode
User Guidelines
Once interface tracking is enabled, the VRRPv3 feature receives notifications
when an interface changes state. The decrement option decreases the priority
of the switch within a VRRPv3 group by the specified value when an interface
goes down.
Command History
Command introduced in version 6.6 firmware.
Example
The following example shows how to set IP address of the device within a
Virtual Router Redundancy Protocol (VRRPv3) group:
console(config-if-vrrp)#track ip route 2001::1/64 secondary