Users Guide

Switch Management Commands 1922
show sntp configuration
Use the show sntp configuration command to show the configuration of the
Simple Network Time Protocol (SNTP).
Syntax
show sntp configuration
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
Loopback interfaces are not supported on the N1100-ON Series switches.
Example
The following example displays the current SNTP configuration of the
device.
console#show sntp configuration
Polling interval: 64 seconds
MD5 Authentication keys:
Authentication is not required for synchronization.
Trusted keys: No trusted keys
No trusted keys.
Unicast clients: Disable
Unicast servers:
Server Key Polling Priority Source Interface
-------------- ----------- ----------- ---------- ----------------
10.27.128.21 Disabled Enabled 1 Loopback 1
show sntp server
Use the show sntp server command to display the preconfigured SNTP
servers. The configured servers can be either IPv4 or IPv6 format.