Users Guide

Switch Management Commands 2033
interface out-of-band
Use the interface out-of-band command to enter into OOB interface
configuration mode.
Syntax
interface out-of-band
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration
User Guidelines
This command is not available on the N1100-ON/N1500/N2000/N2100-
ON/N2200-ON Series switches.
Example
console(config)#interface out-of-band
console(config-if)#
ip address
Use the ip address command to configure an IP address on an in-band VLAN
or loopback interface. Also use this command to configure one or more
secondary IP addresses on the interface.
Syntax
ip address ip-address {{subnet-mask | prefix-length}
[secondary]|dhcp|none}
no ip address ip-address {subnet-mask | prefix-length} [secondary]
• ip-address — IP address of the interface.
• dhcp — Obtain the address from a DHCP server.
• none — Clear the address assignment method.