Users Guide

Switch Management Commands 2078
The maximum configurable power limit is 30000 milliwatts for two-pair
power. The maximum configurable power limit is 60000 milliwatts for four-
pair power. The actual power delivered in two-pair or four-pair mode may
exceed the user-defined limit. Refer to the Class Power Limits and Margin
table in the Dell EMC Networking User’s Configuration Guide for more
information.
Example
This example configures interface Gi1/0/1 to deliver 60W four-pair power.
console#configure
console(config)#power inline management static
console(config)#interface gi1/0/1
console(config-if-Gi1/0/1)#power inline four-pair forced
This example configures interface Gi1/0/2 to deliver 50W four-pair power
(within the 5% tolerance). The port will deliver up to 52500 mW.
console#configure
console(config)#power inline management static
console(config)#interface gi1/0/2
console(config-if-Gi1/0/2)#power inline four-pair forced
console(config-if-Gi1/0/2)#power inline limit user-defined 50000
This example displays an interface configured in four-pair power mode.
console#show power inline gigabitethernet 1/0/1 detailed
Port Powered Device State Priority Status Class Power[mW]
Detected/Assigned
------ -------------- ------ -------------- ----- --------- --------
Gi1/0/1 auto Low Searching/Unknown
Limit Power High Power
Port Type Limit Mode
--------- -------- -------- -----------
Gi1/0/1 None 57000 Enabled
Overload Counter............................... 0
Short Counter ................................. 0
Denied Counter................................. 0
Absent Counter................................. 0
Invalid Signature Counter...................... 0
Output Voltage (Volts)......................... 53
Output Current (mAmps)......................... 0