Users Guide

Switch Management Commands 2206
SupportAssist Commands
The commands in this section enable configuration of SupportAssist.
eula-consent
Use the eula-consent command to accept or reject the end-user license
agreement (EULA) for the SupportAssist service.
Syntax
eula-consent {support-assist} {accept | reject}
• support-assist—Enter the keyword support-assist to either accept or
reject the EULA for the SupportAssist service.
• accept — Accepts the EULA for the specified service.
• reject — Rejects the EULA for the specified service.
Default Configuration
The default is eula-consent support-assist accept.
Command Mode
Global Configuration
User Guidelines
Messages are shown for both the accept and reject use cases with information
directing the user to URLs for further information. If the user rejects or has
not yet accepted the EULA, the configuration mode for the specified service
will not be usable. If there is existing configuration for that feature, the
configuration will not be removed but the feature will be disabled.
This command can be executed multiple times. It overwrites the previous
information each time. The collected information is stored in the running-
config. The administrator must write the configuration in order to persist it
across reboots.
Command History
Introduced in version 6.3.0.1 firmware.