Users Guide

Switch Management Commands 2210
User Guidelines
The email address must conform to RFC 5322 sections 3.2.3 and 3.4.1 and
RFC 5321. Additionally, the character set is further restricted to ASCII
characters.
This information is transmitted to Dell if the SupportAssist service is
enabled.
This command can be executed multiple times. It overwrites the previous
information each time. The collected information is stored in the running-
config. The administrator must write the configuration in order to persist it
across reboots.
Command History
Introduced in version 6.3.0.1 firmware.
Example
The following example
console(config)# support-assist
console(conf-support-assist)#contact-person first john last doe email-
address primary [e-mail] phone [phone] preferred-method
email
enable
Use the enable command to enable a SupportAssist server. Use the no form of
the command to disable a SupportAssist server.
Syntax
enable
no enable
Default Configuration
By default, the default server is enabled. It may be disabled using the no
enable form of the command.
Command Mode
Support Assist Configuration