Users Guide
Switch Management Commands 2256
Syntax
hardware profile portmode {1x40g | 4x10g }
hardware profile portmode {1x100g | 2x50g | 4x25g }
no hardware profile portmode
The available modes depend on the platform.
N2200 only:
• 1x40g: Configure the port as a single 40G port using four lanes.
• 4x10g: Configure the port as four 10G ports, each on a separate lane.
N3200 only:
• 1x100g: Configure the port as a single 1x100G port using one lane.
• 2x50g: Configure the port as two 50G ports, each on a separate lane.
• 4x25g: Configure the port as a four 25G ports, each on a separate lane.
• The 25G ports may also operate at 10G speeds.
Default Configuration
• By default, 40G ports are configured in 1x40G stacking mode.
• By default, 100G ports are configured in 2x50G stacking mode.
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
This command can only be executed on a 40G or 100G Ethernet interface
that supports the expandable ports feature. Entering this command on any of
the 4x10G, 2x50G, or 4x25G Ethernet interfaces (or any non-Ethernet port)
will give an error. Entering the command on a non-expandable type of
interface will give an error.
When an expandable port is configured to operate in Ethernet mode, a
breakout cable may be used to connect to other switches or hosts.
When the stack port is configured in Ethernet mode, the stack ports and the
non-configured Ethernet ports show as detached in the output of the
show
interfaces status
command. For example, if the port is configured as 100G