Users Guide

Switch Management Commands 2272
Syntax
reload [stack–member–number]
• stack–member–number—The stack member to be reloaded.
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode
User Guidelines
If no unit is specified, all units in a stack are reloaded. When copying
firmware onto the switch in a stacked configuration, use the show sfs and
show version commands to check the status of stack firmware
synchronization prior to a reboot.
Examples
Example-Reloading the Stack
The following example displays how to reload the stack.
console#reload 1
Management switch has unsaved changes.
Would you like to save them now? (y/n)n
Configuration Not Saved!
Are you sure you want to reload the switch? (y/n) y
Reloading management switch 1.
Example-Stack Port Errors
The following example shows stack port errors detected by the command.
console#reload
Management switch has unsaved changes.
Are you sure you want to continue? (y/n)
Warning! Stack port errors detected on the following interfaces:
Interface Error Count
---------------- ----------------
Gi1/0/1 12
Gi1/0/3 22