Users Guide

Switch Management Commands 2273
Stack port errors may indicate a non-redundant stack topology exists. Fail-
over on a non-redundant topology may cause the stack to split!
Are you sure you want to reload the stack? (y/n)
service unsupported-transceiver
Use this command to avoid the following on using an unsupported optic.
• Logging of a message.
• Generation of SNMP trap.
Use the no form of this command to set the transceiver support to the factory
default.
Syntax
service unsupported-transceiver
no service unsupported-transceiver
Default Configuration
The default configuration is to log a message along with the SNMP trap
generation on insertion or removal of an optic that is not qualified by Dell.
Command Mode
Global Configuration mode
User Guidelines
The switch logs a message and generates a trap on inserting or removing an
optics not qualified by Dell. This command suppresses the above mentioned
behavior.
Example
The following example bypasses logging of a message and trap generation on
inserting or removing an optics not qualified by Dell.
console(config)# service unsupported-transceiver