Users Guide

Layer 2 Switching Commands 327
switchport voice detect auto
The switchport voice detect auto command is used to enable the VoIP Profile
on all the interfaces of the switch (global configuration mode) or for a specific
interface (interface configuration mode).Use the no form of the command to
disable the VoIP Profile.
Syntax
switchport voice detect auto
no switchport voice detect auto
Default Configuration
This feature is disabled by default.
Command Mode
Global Configuration mode
User Guidelines
The switch Auto-VoIP capability is independent of the Voice VLAN capability.
Voice VLAN configuration has no effect on the Auto-VoIP capabilities. Voice
VLAN is recommended for enterprise deployments as Auto-VoIP is limited in
the number of active VoIP users that can be serviced.
This command is valid for Ethernet and port channel interfaces.
Example
console(config)#interface tengigabitethernet 1/0/1
console(config-if-Te1/0/1)#switchport voice detect auto