Users Guide

Layer 2 Switching Commands 412
show interfaces configuration
Use the show interfaces configuration command in User Exec mode to
display the configuration for all configured interfaces.
Syntax
show interfaces configuration [{gigabitethernet unit/slot/port| port-channel
port-channel-number | tengigabitethernet unit/slot/port |
fortygigabitethernet unit/slot/port}]
Default Configuration
This command has no default configuration.
Command Mode
User Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
The displayed port configuration information includes the following:
Example
The following example displays the configuration for all configured
interfaces:
Field Description
Port The port number.
Description The port designated IEEE shorthand identifier. For example
1000Base-T refers to 1000 Mbps baseband signaling including both
Tx and Rx transmissions.
Duplex Displays the port Duplex status.
Speed Refers to the port speed.
Neg Describes the Auto-negotiation status.
MTU The Maximum Transmission Unit.
Admin State Displays whether the port is enabled or disabled.