Users Guide

Layer 2 Switching Commands 424
User Guidelines
This command only supports the display of 10G and 40G transceivers.
Example
The following example shows the qualifications status of the optics on the
switch.
console#show interfaces transceiver
Port Dell EMC Qualified
------------- ------------------
Te1/0/9 Yes
Te1/0/11 Yes
Te1/0/13 N/A
Te1/0/15 No
Te1/0/17 No
The following example shows static parameters of the optics along with the
qualifications status.
console#show interfaces transceiver properties
Yes: Dell EMC Qualified No: Not Qualified
N/A : Not Applicable
Port Type Media Serial Number Dell EMC Qualified
------------ ------- --------------- -------------------- ------------------
Te1/0/9 SFP+ 10GBASE-LRM ANF0L5J Yes
Te1/0/11 SFP+ 10GBASE-LRM ANF0L5R Yes
Te1/0/13 SFP 1GBASE-SX PCC1PT5 N/A
Te1/0/15 SFP+ 10GBASE-SR AD1125A002R No
Te1/0/17 SFP+ 10GBASE-SR AD0815E00PC No
show interfaces trunk
Use the show interfaces trunk command to display active trunk interface
information.
Syntax
show interfaces trunk [interface-id]
• interface-id—An Ethernet or port channel interface identifier.