Users Guide

Layer 2 Switching Commands 467
console (config-erp-ring1)#port0 interface te1/0/1
console (config-erp-ring1)#port1 interface te1/0/2
console (config-erp-ring1)#instance 1
console (config-erp-inst-1)#rpl port1 owner
On the adjacent switch:
console (config)# ethernet ring g8032 ring1
console (config-erp-ring1)#timer hold-off 500
console (config-erp-ring1)#port0 interface te1/0/1
console (config-erp-ring1)#port1 interface te1/0/2
console (config-erp-ring1)#instance 1
console (config-erp-inst-1)#rpl port0 neighbor
Command History
Command introduced in firmware release 6.6.1.
inclusion-list
Use the inclusion-list command to select the VLANs protected by the
Ethernet ring protection instance. Use the no inclusion-list command to
remove VLANs from protection.
Syntax
inclusion-list vlan-ids { vlan-id [, vlan-id]… |vlan-range]
no inclusion-list vlan-ids { vlan-id [, vlan-id]… |vlan-range]
• vlan-id —The VLAN identifier of an existing VLAN to be protected.
• vlan-range —A range of VLANs to be protected.
Default Configuration
There are no VLANs protected by an instance by default.
Command Mode
Ethernet Ring Instance Configuration mode