Users Guide

Layer 2 Switching Commands 480
Example
console#show ethernet ring g8032 status ring1 instance 1
Ethernet ring………………………..ring1
Instance……………………………1
Node Type …………………… ….Owner
Node State…………………………Idle
Open ring……………………………No
Port0……………………………….0/1
APS-Channel……………………. 10
Status……………………………. RPL, blocked
Remote R-APS………………….. NodeId 00:90:56:26:45:12, BPR: 0
Port1……………………………….0/2
APS-Channel……………………10
Status………………………………Non-RPL
Remote R-APS…………………….NodeId 00:0a:f7:94:e4:0a, BPR: 0
R-APS Level………………………6
Profile………………………………profile1
WTR interval…………………….. 1 minutes
Guard interval……………………..2000 milliseconds
HoldOffTimer…………………….0 seconds
Revertive mode…………………..Enabled
console#show ethernet ring g8032 status ring1 instance 1
Ethernet ring………………………..ring1
Instance……………………………1
Node Type …………………… ….Owner
Node State…………………………Idle
Open ring……………………………No
Port0……………………………….0/1
APS-Channel……………………. 10
Status……………………………. RPL, blocked
Remote R-APS………………….. NodeId 00:90:56:26:45:12, BPR: 0
Port1……………………………….0/2
APS-Channel……………………10
Status………………………………Non-RPL
R-APS Level Level that is used in R-APS messages.
Profile Profile that is mapped for the instance. If the profile is
not configured, the command output displays Not
Configured. Also displays the default values for timers
and revertive mode.
Table 3-5. show ethernet ring g8032 status command output
Field Description