Users Guide

Layer 2 Switching Commands 590
• ip: IPv4 address filtering
• ipv6: IPv6 address filtering
• ipv6-mac: IPv6 plus MAC address filtering
• N/A: No filtering is configured on the interface
Example
console(config-if-Gi1/0/5)#show ip verify
Interface Filter Type
----------- -----------
Gi1/0/1 ip
Gi1/0/2 ipv4-mac
Gi1/0/3 N/A
Gi1/0/4 N/A
Gi1/0/5 ipv4-mac
Gi1/0/6 N/A
Gi1/0/7 N/A
Gi1/0/8 N/A
Gi1/0/9 N/A
console(config-if-Gi1/0/5)#show ip verify interface gi1/0/5
Interface Filter Type
----------- -----------
Gi1/0/5 ipv6-mac
show ip verify source
Use the show ip verify source command to display the bindings configured on
a particular interface or all interfaces.
Syntax
show ip verify source [interface interface-id]
• interface-id: A valid Ethernet interface identifier or port-channel identifier
Default Configuration
There is no default configuration for this command.