Users Guide

Layer 2 Switching Commands 631
Command History
Implemented in version 6.3.0.1 firmware. Syntax corrected in 6.4 release.
Example
The following example configures loop protection to log detected loop
conditions without error disabling the port.
console(config)#interface gi1/0/1
console(config-if-Gi1/0/1)#keepalive action log-only
show keepalive
Use the show keepalive command to display the global loop protect
configuration.
Syntax
show keepalive
Default Configuration
There is no default configuration.
Command Mode
Privileged Exec mode and configuration submodes.
User Guidelines
The following information is displayed.
Field Description
Keepalive Service The Keepalive service configuration
(Enabled, Disabled).
Transmit Interval The transmission interval in seconds.
Retry Count The number of times a keepalive packet
must be seen before a looped state is
declared.