Users Guide

Layer 2 Switching Commands 651
Peer link BPDU’s Tx error.............................. 9
Peer link BPDU’s received from peer.................... 143
Peer link BPDU’s Rx error.............................. 1
Peer link LACPDU’s transmitted to peer................. 123
Peer link LACPDU’s Tx error............................ 9
Peer link LACPDU’s received from peer.................. 143
Peer link LACPDU’s Rx error............................ 1
(console)#show vpc statistics peer-link
Peer link control messages transmitted......... 24
Peer link control messages Tx errors........... 0
Peer link control messages Tx timeout.......... 0
Peer link control messages ACK transmitted..... 23
Peer link control messages ACK Tx errors....... 0
Peer link control messages received............ 23
Peer link data messages transmitted............ 73
Peer link data messages Tx errors.............. 0
Peer link data messages Tx timeout............. 0
Peer link data messages received............... 73
Peer link BPDU's transmitted to peer........... 0
Peer link BPDU's Tx errors..................... 0
Peer link BPDU's received from peer............ 0
Peer link BPDU's Rx errors..................... 0
Peer link LACPDU's transmitted to peer......... 73
Peer link LACPDU's Tx errors................... 0
Peer link LACPDU's received from peer.......... 73
Peer link LACPDU's Rx errors................... 0
system-mac
Use this command to manually configures the MAC address for the VPC
domain. Use the no form of the command to revert the domain MAC address
to the default value.
Syntax
system-mac mac-address
no system-mac
• mac-address—The system MAC address for the VPC domain.
Default Configuration
By default, the domain uses a pre-configured MAC address.
Command Modes
VPC domain mode