Users Guide

1210 IP Routing
Configuring IP Routing Features (CLI)
This section provides information about the commands used for configuring
IPv4 routing on the switch. For more information about the commands, see
the
Dell EMC Networking N1100-ON, N1500, N2000, N2100-ON, N2200-
ON, N3000E-ON, N3100-ON, and N3200-ON Series Switches CLI Reference
Guide
at www.dell.com/support.
Configuring Global IP Routing Settings
Use the following commands to configure various global IP routing settings
for the switch.
Command Purpose
configure Enter global configuration mode.
ip routing Globally enable IPv4 routing on the switch.
ip icmp echo-reply Allow the switch to generate ICMP Echo Reply messages.
ip icmp error-interval
burst-interval [ burst-
size
]
Limit the rate at which IPv4 ICMP error messages are sent.
•
burst-interval — How often the token bucket is
initialized (Range: 0–2147483647 milliseconds).
•
burst-size — The maximum number of messages that
can be sent during a burst interval (Range: 1–200).
ip redirects Allow the switch to generate ICMP Redirect messages.
ip default-gateway
ip-
address
Configure the global default gateway for the switch. The
gateway configured here takes precedence over a default
gateway assigned by a network DHCP server.
exit Exit to Privileged Exec mode.
show ip brief View the global IP settings for the switch.