Users Guide

Table Of Contents
248 Setting Basic Network Information
Basic Network Information Configuration
Examples
Configuring Network Information Using the OOB Port
In this example, an administrator at a Dell office in California decides not to
use the Dell Easy Setup Wizard to perform the initial switch configuration.
The administrator configures Dell EMC Networking N2200-ON, N3000E-
ON, N3100-ON and N3200-ON Series switches to obtain information from a
DHCP server on the management network and creates the administrative
user with read/write access. The administrator also configures the following
information:
Primary DNS server: 10.27.138.20
Secondary DNS server: 10.27.138.21
Default domain name: sunny.dell.com
The administrator also maps the administrative laptop host name to its IP
address. The administrator uses the OOB port to manage the switch.
To configure the switch:
1
Connect the OOB port to the management network. DHCP is enabled by
on the switch OOB interface by default on Dell EMC Networking
N3000E-ON, N3100-ON, and N3200-ON Series switches. DHCP is
enabled on VLAN 1 on the Dell EMC Networking N1100-
ON/N1500/N2000/N2100-ON S
eries
switches as they do not support an
OOB interface. If the DHCP client on the switch has been disabled, use
the following commands to enable the DHCP client on the OOB port.
console#configure
console(config)#interface out-of-band
console(config-if)#ip address dhcp
console(config-if)#exit
2
Configure the administrative user.
console(config)#username admin password secret123 privilege 15
NOTE: Dell EMC Networking N1100-ON, N1500, N2000, and N2100-ON Series
switches do not have an out-of-band interface.