Users Guide

276 Stacking
Managing the Stack (CLI)
This section provides information about the commands for managing the
stack and viewing information about the switch stack. For more information
about these commands, see the
Dell EMC Networking N1100-ON, N1500,
N2000, N2100-ON, N2200-ON, N3000E-ON, N3100-ON, and N3200-ON Series
Switches CLI Reference Guide
at www.dell.com/support.
Configuring Stack Member, Stack Port, SFS and NSF Settings
Use the following commands to configure stacking and SFS settings.
Command Purpose
configure Enter Global Configuration mode.
switch
current_ID
renumber
new_ID
Change the switch ID number.
Changing the ID number causes all switches in the stack
to be reset to perform management unit in the stack
renumbering. The running configuration is cleared when
the units reset.
stack Enter Global Stack Configuration mode.
initiate failover Move the management switch functionality from the
primary switch to the standby switch.
standby
unit Specify the stack member that will come up as the
primary if a stack failover occurs.
set description
unit
<text>
Configure a description for the specified stack member.