Users Guide

504 Managing General System Settings
Configuring the Expansion Slots
This section applies to Dell EMC Networking N3000E-ON/N3100-ON Series
Only.
Use the following commands to configure and view information about the
expansion slots and plug-in modules (cards).
clock summer-time
date {
date month |
month date } year
hh:mm
{ date month |
month dat e} year
hh:mm
[offset offset ]
[zone
acronym ]
Use this command if the summer time does not start and
end every year according to a recurring pattern. Enter the
month and then the date, or the date and then the month.
•
date — Day of the month. (Range: 1-31.)
•
month — Month. (Range: The first three letters by name)
•
hh:mm — Time in 24-hour format in hours and minutes.
(Range: hh: 0–23, mm: 0–59)
•
offset — Number of minutes to add during the
summertime. (Range:1–1440)
•
acronym — The acronym for the time zone to be displayed
when summertime is in effect. (Range: Up to four
characters)
CTRL + Z Exit to Privileged Exec mode.
show clock [detail] View information about the time. Include the detail
keyword to view information about the time zone and
summer time.
Command Purpose
configure Enter Global Configuration mode.
slot
unit/slot cardindex Configured the specified slot (1–2) to use the plug-in
module identified by the
cardindex number (CID). To
view the CID associated with each plug-in module, use the
show supported cardtype command.
CTRL + Z Exit to Privileged Exec mode.
show slot Display status information about the expansion slots.
show supported cardtype Display information about the plug-in modules the switch
supports.
Command Purpose