Users Guide

680 Port Characteristics
For many features, a range of interfaces can be specified. When you enter
Interface Configuration mode for multiple interfaces, the commands you
execute apply to all interfaces specified in the range.
To enter Interface Configuration mode for a range of interfaces, include the
keyword range and specify the interfaces to configure. For example, to apply
the same configuration to 10G Ethernet interfaces 1-10 on a standalone
switch, use the following command:
console(config)#interface range tengigabitEthernet 1/0/1-10
To enter Interface Configuration mode for 10G Ethernet interfaces 3, 4, 5,
12, and 14 on a standalone switch, use the following command:
console(config)#interface range tengigabitEthernet 1/0/3-
5,1/0/12,1/0/14
What Are the Green Ethernet Features?
The Green Ethernet feature supports two per-port power-saving modes:
• Energy-detect Mode
• EEE
All integrated 1G and module-based 10G copper ports on Dell EMC
Networking N-Series switches are capable of utilizing the Energy Detect and
EEE modes for reduced power consumption.
When the Energy Detect mode is enabled and the port link is down, the PHY
automatically goes down for short period of time and then wakes up to check
link pulses. This mode reduces power consumption on the port when no link
partner is present.
EEE enables ports to enter a low-power mode to reduce power consumption
during periods of low link utilization. EEE is defined by IEEE 802.3az. EEE
enables both the send and receive sides of the link to disable some
functionality for power savings when the link is lightly loaded. EEE requires
auto-negotiation to be enabled on the port.
NOTE: To switch to another interface or range of interfaces, enter the interface
command while in Interface Configuration mode. It is not necessary to exit
Interface Configuration mode to select a different interface.