Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch N1500 Series
1231123212331234123512361237123812391240
Table Of Contents
Data Center Technology Commands 1234
OpenFlow Commands
Dell EMC Networking N2000/N2100-ON/N2200-ON/N3000-
ON/N3100-ON/N3200-ON Series Switches
The OpenFlow feature configures the switch to be managed by a centralized
OpenFlow Controller using the OpenFlow protocol. Openflow is not
supported in a stacking environment. The OpenFlow agent has been
validated with the Helium release of OpenDaylight (ODL).
controller
Use the controller command to configure a connection to an OpenFlow
controller. Use the no form of the command to remove an OpenFlow
controller connection.
Syntax
controller ipv4
ipv4-address
[port
port-number
] security { none | ssl }
no controller ipv4 {
ipv4-address
[port
port-number
] | all }
•
ipv4-address
—The IPv4 address of the controller.
•
port-number
—The TCP port number used for the connection on the
controller.
• security { none | ssl }—The security used for connection to the controller.
• all—Delete all OpenFlow controllers
Default Configuration
No controllers are configured by default.
Command Mode
OpenFlow Configuration