Users Guide

Layer 3 Routing Commands 1857
show ipv6 ospf lsa-group
Use this command to display the number of self-originated LSAs within each
LSA group.
Syntax
show ipv6 ospf lsa-group [vrf vrf-name ]
•
vrf-name — The name of an existing VRF instance.
• Total self-originated LSAs — The number of LSAs the router is currently
originating.
• Average LSAs per group — The number of self-originated LSAs divided by
the number of LSA groups. The number of LSA groups is the refresh
interval (1800 seconds) divided by the pacing interval (configured with
timers pacing lsa-group ) plus two.
• Pacing group limit — The maximum number of self-originated LSAs in
one LSA group. If the number of LSAs in a group exceeds this limit, OSPF
redistributes LSAs throughout the refresh interval to achieve better
balance.
• Groups — For each LSA pacing group, the output shows the range of LSA
ages in the group and the number of LSAs in the group.
Command Mode
User Exec, Privileged Exec mode, VRF Configuration
Example
The following shows an example of the command.
(R1) #show ipv6 ospf lsa-group
Total self-originated LSAs: 3019
Average LSAs per group: 100
Pacing group limit: 400
Number of self-originated LSAs within each LSA group...
Group Start Age Group End Age Count
0 59 96
60 119 88
120 179 102
180 239 95