Users Guide

Switch Management Commands 2007
When copying files to or from a USB stick, do not remove the USB stick
during file transfer. Use the unmount command to cleanly detach the USB
stick before physical removal. After running the unmount command, the USB
stick must be physically removed and re-inserted before accessing again.
An ONIE firmware image may be copied onto the management unit in the
stack using the onie-fw-update destination URL. ONIE firmware updates are
distributed to the stack member automatically and are executed on stack
reboot. The management unit in the stack requires at least 10 minutes after
the image has been copied on to the primary to distribute the images across
the stack.
Examples
Example – Backing up the running-config
console#copy running-config backup-config
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to save? (y/n) y
Configuration saved!
Example – Downloading new code to the switch
console#copy tftp://10.27.9.99/jmclendo/N3000-ONv6.0.1.3.stk backup
Transfer Mode.................................. TFTP
Server IP Address.............................. 10.27.9.99
Source File Path............................... jmclendo/
Source Filename................................ N3000-ONv6.0.1.3.stk
Data Type...................................... Code
Destination Filename........................... backup
Management access will be blocked for the duration of the transfer
Are you sure you want to start? (y/n) y
File transfer in progress. Management access will be blocked for the duration
of the transfer. please wait...
TFTP Code transfer starting...
17128797 bytes transferred...
File contents are valid. Copying file to flash...