Users Guide

Security Commands 974
Command History
Syntax updated in version 6.6 firmware.
Example
The following example enables dynamic VLAN creation using the value
provided in the Access-Accept message.
console(config)# authentication dynamic-vlan enable
authentication enable
Use this command to globally enable the Authentication Manager. Interface
configuration set with the authentication order command takes effect only if
the Authentication Manager is enabled.
Use the no form of this command to disable the Authentication Manager.
Syntax
authentication enable
no authentication enable
Default Configuration
The default value is Disabled.
Command Mode
Global Configuration mode
User Guidelines
The administrator must ensure that any methods configured by the
Authentication Manager are enabled (e.g. enable IEEE 802.1x using the
dot1x system-auth-control command). Enable MAB using the mab
command.
Example
console(config)# authentication enable