CLI Guide

Security Commands 1012
User Guidelines
The Acct-Session-ID is the same as the session identifier used in accounting
messages.
Command History
Command introduced in version 6.6.0.1 firmware.
attribute 168
Use the attribute 168 include-in-access-req command to enable the switch to
send the RADIUS Framed-IPv6-Address attribute in Access-Request
messages sent to the RADIUS authentication server.
Syntax
attribute 168 include-in-access-req
no attribute 168 include-in-access-req
Default Configuration
By default, RADIUS attribute 168 is not sent.
Command Mode
RADIUS Server Configuration mode.
User Guidelines
The switch sends the IPv6 address of the host attempting to access the
network in the Framed-IPv6-Address attribute if it is available to the switch.
If accounting is enabled and the address is available to the switch, the switch
will send the IPv6 address in the Access-Request, Acct-Start/Acct-
Interim/Acct-Stop messages sent to the accounting server.
The switch discovers the client IPv6 address via its inclusion in the RADIUS
Access-Accept, or via DHCPv6 snooping. DHCPv6 snooping must be enabled
for the switch to discover a host IPv6 address via DHCPv6.