CLI Guide

Security Commands 1044
traffic ingressing the port. If there are syntax errors in the received ACLs
(other than duplicate rules), the ACL rules are not applied, the RADIUS
Access-Accept is treated as an Access-Reject, and a WARN log message or
"Interface X/X/X not authorized. Application of downloaded
ACL did not complete due to invalid syntax XXXXX
" is issued
indicating that a received RADIUS rule is misconfigured with invalid syntax
or configured with both ip:traffic-class and inacl rules and identifying the
affected interface. If Accounting is enabled, the Acct-Start packet is not sent.
An EAP-Failure is sent to the 802.1X client.
Command History
Command introduced in firmware version 6.5.2.
retransmit
Use the retransmit command in RADIUS Server Configuration mode to
specify the number of times the RADIUS client retransmits requests to the
RADIUS server.
Syntax
retransmit retries
• retries — Specifies the retransmit value. (Range: 1-10 attempts)
Default Configuration
The default number for attempts is 3.
Command Mode
RADIUS mode
User Guidelines
The administrator must enter the mode corresponding to a specific RADIUS
server before executing this command. This command overrides the global
configuration.
Example
The following example of the retransmit command specifies five retries.