CLI Guide

Security Commands 1052
Command Mode
RADIUS Server Configuration mode
User Guidelines
The administrator must enter the mode corresponding to a specific RADIUS
server before executing this command. This command overrides the global
configuration for the selected server.
Example
The following example specifies 10.240.1.23 as the source IP address.
console(config)#radius server host 192.143.120.123
console(config-auth-radius)#source-ip 10.240.1.23
timeout
Use the timeout command in RADIUS mode to set the timeout value in
seconds for the designated RADIUS server.
Syntax
timeout timeout
• timeout — Timeout value in seconds for the specified server. (Range: 1-30
seconds.)
Default Configuration
The default value is 15 seconds.
Command Mode
RADIUS Server Configuration mode
User Guidelines
The administrator must enter the mode corresponding to a specific RADIUS
server before executing this command. This command overrides the global
configuration for the selected server.