CLI Guide

Security Commands 1104
Host Mode ..................................... multi-auth
Method......................................... 802.1X
Control Mode................................... auto
Session time ... .............................. 0
Session timeout ............................... 0
Session Termination Action..................... Default
Filter-Id ..................................... None
DACL........................................... None
Session Termination Action..................... Default
Acct SessionId:................................ test:200000003
show dot1x interface
This command shows the status and configuration of an IEEE 802.1x
configured interface.
Syntax
show dot1x interface interface-id
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
The command accepts Ethernet interface identifiers.
The following describes the fields in the output. All times are in seconds:
• Transmit Period —The time period between two successive EAP
RequestId packets if the Supplicant does not respond 1 – 65535 sec 30 sec
• Supplicant Timeout—The timeout period when waiting for a response
from the Supplicant1 – 65535 sec 30 sec
• Server Timeout —The timeout period when waiting for a response from
the RADIUS Server1 – 65535 sec 30 sec
• Maximum Requests —The maximum number of EAP packet
retransmissions to a Supplicant other than RequestId packets 1 – 20 sec 2