CLI Guide

Layer 3 Routing Commands 1255
Command History
Introduced in version 6.3.0.1 firmware.
Example
console(config-router)# address-family ipv4 vrf Red
address-family ipv6
Use the address-family ipv6 command to enter IPv6 family configuration
mode to specify IPv6 configuration parameters. Use the no form of the
command to delete all IPv6 configuration.
Syntax
address-family ipv6
no address-family ipv6
Default Configuration
By default, the exchange of IPv6 routes is disabled.
Command Mode
BGP Router Configuration mode
User Guidelines
The address-family ipv6 command moves the CLI to IPv6 address family
configuration mode. Commands entered in this mode can be used to enable
exchange of IPv6 routes over IPv6 or IPv4 peering sessions, specify IPv6
prefixes to be originated, and configure inbound and outbound policies to be
applied to IPv6 routes. The no version of this command clears all IPv6 address
family configuration
ASNs 0, 56320–64511, and 65535 are reserved cannot be used.
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-router)# address-family ipv6