CLI Guide

Layer 3 Routing Commands 1273
• in | out—If the in keyword is given, updates from the neighbor are
reprocessed. If the out keyword is given, updates are resent to the neighbor.
If neither keyword is given, updates are reprocessed in both directions.
Default Configuration
There is no default configuration.
Command Mode
Privileged Exec mode
User Guidelines
Soft inbound reset causes BGP to send a Route Refresh request to each
neighbor being reset. If a neighbor does not support the Route Refresh
capability, the updated policy is applied to routes previously received from the
neighbor.
When a change is made to an outbound policy, BGP schedules an outbound
soft reset to update neighbors according to the new policy.
This command applies to routes for all address families.
When clear ip bgp is issued for any peers, any pending policy configuration
changes are applied, for all global policy and for all peers.
Command History
Introduced in version 6.2.0.1 firmware. Updated in version 6.3.0.1 firmware.
Command updated in version 6.6 firmware.
Example
console(config-router)#clear ip bgp
clear ip bgp counters
Use the clear ip bgp counters resets all BGP counters to 0. These counters
include send and receive packet and prefix counters for all neighbors.
Syntax
clear ip bgp [vrf vrf-name] counters