CLI Guide

Layer 3 Routing Commands 1324
hold times, both passwords must be changed within 120 seconds to guarantee
the connection is not dropped. The VLAN interface must also be specified if
a link-local address is specified.
Command History
Introduced in version 6.2.0.1 firmware.
Updated in version 6.3.0.1 firmware.
Example
console(config-router)#neighbor FE80::0202:B3FF:FE1E:8329 interface vlan 10
password sample
neighbor prefix-list (BGP Router Configuration)
Use the neighbor prefix-list command to filter advertisements sent to a
specific neighbor based on the destination prefix of each route.
Syntax
neighbor { ip-address | ipv6-address [interface vlan vlan-id]} prefix-list
prefix-list-name { in | out }
no neighbor { ip-address | ipv6-address [interface vlan vlan-id]} prefix-list
prefix-list-name { in | out }
• ip-address—The neighbor’s IPv4 address.
• prefix-list-name—The name of an IP prefix list.
• ipv6-address—The neighbor’s IPv6 address. If the neighbor’s IPv6 address
is a link local address, the local interface must also be specified. This
command is available in IPv6 address family mode.
• interface vlan vlan-id—The local interface/VLAN ID over which the IPv6
neighbor can be reached. Range: 1-4093.
• in—Apply the prefix list to advertisements received from this neighbor.
• out—Apply the prefix list to advertisements to be sent to this neighbor.
Default Configuration
No prefix list is configured.