CLI Guide

Layer 3 Routing Commands 1367
Configured Hold Time.......................... 90 sec
Configured Keep Alive Time.................... 30 sec
Negotiated Hold Time.......................... 30 sec
Keep Alive Time............................... 10 sec
MD5 Password.................................. password
Last Error (Sent).............................. Hold Timer Expired
Last SubError.................................. None
Time Since Last Error.......................... 0 day 0 hr 4 min 27 sec
Established Transitions........................ 1
Established Time............................... 0 day 0 hr 4 min 25 sec
Time Since Last Update......................... 0 day 0 hr 4 min 24 sec
IPv6 Outbound Update Group..................... 7
Open Update Keepalive Notification Refresh Total
Msgs Sent 1 0 10 0 0 11
Msgs Rcvd 1 1 11 0 0 12
Received UPDATE Queue Size: 0 bytes. High: 355. Limit 196096. Drops 0.
IPv6 Prefix Statistics:
Inbound Outbound
Prefixes Advertised 1 0
Prefixes Withdrawn 0 0
Prefixes Current 1 0
Prefixes Accepted1 N/A
Prefixes Rejected 1 N/A
Max NLRI per Update 1 0
Min NLRI per Update 1 0
show bgp ipv6 neighbors advertised-routes
Use this command to display IPv6 routes advertised to a specific neighbor.
The format and field descriptions are the same as for show ip bgp neighbors
advertised-routes, except that the Network and Next Hop fields show IPv6
addresses. This command deprecates and replaces the show ipv6 bgp
neighbors advertised-routes command.
Syntax
show bgp ipv6 neighbors { ipv4-address | ipv6-address [ interface interface-id
] } advertised-routes
• ipv4-address—The IPv4 address of a BGP peer.