CLI Guide

Layer 3 Routing Commands 1369
Command History
Introduced in version 6.2.0.1 firmware.
Modified in version 6.3.0.1 firmware.
Example
console#show bgp ipv6 neighbors fe80::211:12ff:fe06:4 interface vl10
advertised-routes
BGP table version is 10, local router ID is 0.0.0.100
Status codes: p - advertisement pending
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPref Path Origin
------------------ ---------------- ---------- ------- ------------- ------
1010:10::/64 0 i
2020:20::/64 0 i
show bgp ipv6 neighbors policy
Use this command to display the inbound and outbound IPv6 policies
configured for a specific peer. The output distinguishes policies that are
configured on the peer itself and policies that the peer inherits from a peer
template. This command deprecates and replaces the show ipv6 bgp
neighbors policy command.
Syntax
show bgp ipv6 neighbors [ ipv4-address | ipv6-address [ interface interface-id
] ] policy
• ipv4-address—The IPv4 address of a neighbor may optionally be specified
to limit the output to a single neighbor.
• ipv6-address [ interface interface-id ]—The IPv6 address of a neighbor. If
specified, the output shows only this neighbor. If the neighbor’s address is
a link local address, the interface must be specified.
Origin The value of the origin attribute.
• i—IGP
• e—EGP
• ?—Incomplete