CLI Guide

Layer 3 Routing Commands 1377
show bgp ipv6 update-group
Use this command to report the status of IPv6 outbound groups and their
members. Output and format are the same as for show ip bgp update-group.
This command deprecates and replaces the show ipv6 bgp update-group
command.
Syntax
show bgp ipv6 update-group [ group-index | ipv4-address | ipv6-address [
interface interface-id ] | autodetect interface interface-id ]
• group-index—If specified, this option restricts the output to a single
update group.
• ipv4-address—The IPv4 address of a peer enabled for exchange of IPv6
prefixes. If specified, this option restricts the output to the update group
containing the peer with the given address.
• ipv6-address [ interface interface-id ]—The IPv6 address of a peer. If the
peer address is a link local address, the interface that defines the scope of
the address must also be given. If a peer address is specified, this option
restricts the output to the update group containing the peer with the given
address.
• autodetect interface interface-id —(Optional) The routing interface on
which the neighbor’s link local IPv6 address is auto detected. The
interface-id must be a VLAN routing interface.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
The update send history table show statistics on as many as the fifteen most
recent executions of the update send process for the update group. Items in
the history table are as follows: