CLI Guide

Layer 3 Routing Commands 1389
User Guidelines
Since IPv4 prefixes can only be exchanged over IPv4 peering, the neighbor-
address parameter must be an IPv4 peer address. This option limits the
output to show a single neighbor. If no neighbor address is specified, the
command shows all neighbors enabled for IPv4 prefix exchange.
If the vrf-name argument is specified, information pertaining to that VRF is
displayed.
The following fields are displayed.
Field Description
Remote Address The neighbor’s IP address
Remote AS The neighbor’s autonomous system number
Peer ID The neighbor’s BGP router ID
Peer Admin Status START or STOP
Peer State The adjacency state of this neighbor
Local Port TCP port number on the local end of the connection
Remote Port TCP port number on the remote end of the connection
Connection Retry Interval How long BGP waits between connection retries
Neighbor Capabilities Optional capabilities reported by the neighbor,
recognized and accepted by this router. Codes listed in
the show output are as follows:
• MP: Multiprotocol
• RF: Route Refresh
This version of Dell EMC Networking does not support
any multiprotocol AFI/SAFI pairs other than IPv4
unicast. The presence of this capability does not imply
otherwise.
Next Hop Self If the local router is configured to advertise one of its
own IP addresses as the BGP Next Hop when
advertising a path learned from an external peer.
Update Source The configured value for the source IP address of
packets sent to this peer. This field is only included in
the output if the update source is configured.