CLI Guide

Layer 3 Routing Commands 1405
Command History
Introduced in version 6.2.0.1 firmware.
Updated in version 6.3.0.1 firmware.
Example
console#show ip bgp summary
IPv4 Routing .................................. Enable
BGP Admin Mode ................................ Enable
BGP Router ID ................................. 0.0.0.100
Local AS Number ............................... 65001
Traps ......................................... Disable
Maximum Paths ................................. 1
Maximum Paths iBGP ............................ 1
Default Keep Alive Time ....................... 30
Default Hold Time ............................. 90
Number of Network Entries ..................... 3
Number of AS Paths ............................ 0
Dynamic Neighbors Current/High/Limit .......... 1/1/20
Default Metric ................................ Not Configured
Default Route Advertise ....................... No
Redistributing:
Source Metric Dist List Route Map
--------- ---------- -------------------------------- ----------------------
static
ospf 300
Route Map The name of the route map used to filter redistributed
routes.
Neighbor The IP address of a neighbor.
ASN The neighbor’s ASN.
MsgRcvd The number of BGP messages received from this
neighbor.
MsgSent The number of BGP messages sent to this neighbor.
State The adjacency state. One of IDLE, CONNECT,
ACTIVE, OPEN SENT, OPEN CNFRM, EST.
Up/Down Time How long the adjacency has been in the
ESTABLISHED state, or, if the adjacency is down, how
long it has been down. In days:hours:minutes:seconds.
Pfx Rcvd The number of prefixes received from the neighbor.