CLI Guide

Layer 3 Routing Commands 1552
IPv6 Routing Commands
Dell EMC Networking N1500/N2000/N2100-ON/N2200-ON/N3000-
ON/N3100-ON Series Switches
The Dell Network N1500/N2000/N2100-ON/N2200-ON series supports limited
routing and multicast capabilities. See the Users Configuration Guide section
“Feature Limitations and Platform Constants” for supported capabilities.
The IPv6 version of the routing table manager provides a repository for IPv6
routes learned by dynamic routing protocols or static configuration. RTO6
manages dynamic and static IPv6 routes, redistributes routes to registered
protocols, supports ECMP routes, and supports multiple routes to the same
destination, sorted by preference. IPv6 routing only operates over VLAN
interfaces.
IPv6 Limitations & Restrictions
The following limitations apply:
• IPSec support is not available.
• The DHCPv6 server does not support stateful address configuration.
• Automated router renumbering is not supported.
Commands in this Section
This section explains the following commands:
arp ipv6 nd dad
attempts
ipv6 nd suppress-ra show ipv6 mld host-
proxy groups
clear ipv6 statistics ipv6 nd ra hop-limit
unspecified
ipv6 redirect show ipv6 mld host-
proxy groups detail
ipv6 address ipv6 nd managed-
config-flag
ipv6 route show ipv6 mld host-
proxy interface
ipv6 enable ipv6 nd ns-interval ip route distance show ipv6 mld traffic
ipv6 hop-limit ipv6 nd nud max-
multicast-solicits
ipv6 unicast-
routing
show ipv6 nd raguard
policy