CLI Guide

Layer 3 Routing Commands 1560
Example
console(config-if-vlan3)#ipv6 mld last-member-query-count 5
ipv6 mld last-member-query-interval
The ipv6 mld last-member-query-interval command sets the last member
query interval for the MLD interface, which is the value of the maximum
response time parameter in the group-specific queries sent out of this
interface. Use the “no” form of this command to set the last member query
interval to the default.
Syntax
ipv6 mld last-member-query-interval last-member-query-interval
no ipv6 mld last-member-query-interval
• last-member-query-interval — The last member query interval (Range: 0–
65535 milliseconds).
Default Configuration
The default last member query interval is 1 second.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 mld last-member-query-interval 5000
ipv6 mld host-proxy
This command enables MLD and MLD Proxy on the specified interface.
PIM and DVMRP are not compatible with MLD proxy. Disable PIM/DVMRP
before enabling MLD proxy.
Multicast routing must be enabled for the MLD proxy service to become
operationally enabled