CLI Guide

Layer 3 Routing Commands 1592
Example
console#show ipv6 mld host-proxy groups
Interface................................ vlan 10
Group Address Last Reporter Up Time Member State Filter Mode Sources
------------- -------------- ---------- ----------------- ------------ -----
--
FF1E::1 FE80::100:2.3 00:01:40 DELAY_MEMBER Exclude 2
FF1E::2 FE80::100:2.3 00:02:40 DELAY_MEMBER Include 1
FF1E::3 FE80::100:2.3 00:01:40 DELAY_MEMBER Exclude 0
FF1E::4 FE80::100:2.3 00:02:44 DELAY_MEMBER Include 4
show ipv6 mld host-proxy groups detail
Use the show ipv6 mld host-proxy groups detail command to display
information about multicast groups that MLD Proxy reported.
Syntax
show ipv6 mld host-proxy groups detail
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged Exec, Global Configuration mode and all Configuration submodes
User Guidelines
The following parameters are displayed by this command:
Field Description
Interface The interface number of the MLD-Proxy.
Group Address The IP address of the multicast group.
Last Reporter The IP address of the host that last sent a membership report for
the current group on the network attached to the MLD Proxy
interface (upstream interface).
Up Time (in
secs)
The time elapsed in seconds since last created.