CLI Guide

Layer 3 Routing Commands 1621
ip pim dr-priority
The ip pim dr-priority command in Interface (VLAN) Configuration mode
to administratively configure the advertised designated router (DR) priority
value. Use the no form of this command to return the configuration to the
default.
Syntax
ip pim dr-priority priority
no ip pim dr-priority
• priority — The administratively configured priority (Range: 0–
2147483647).
Default Configuration
The default election priority is 1.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
This command only has an effect if sparse mode is enabled. Lower values are
preferred.
Example
console(if-vlan10)#ip pim dr-priority 32768
ip pim hello-interval
The ip pim hello-interval command in Interface (VLAN) Configuration
mode to administratively configure the frequency of PIM Hello messages on
the specified interface. Use the no form of this command to return the
configuration to the default.
Syntax
ip pim hello-interval interval
no ip pim hello-interval