CLI Guide

Layer 3 Routing Commands 1769
User Guidelines
The VRF identified in the parameter must have been previously created or an
error is returned.
The VRF parameter is only available on the N3000-ON/N3100 series
switches.
The clear ip ospf counters command does not clear the message queue high
water marks.
The following is output.
Example
console# show ip ospf traffic
Time Since Counters Cleared: 4000 seconds
OSPFv2 Packet Statistics
Hello Database Desc LS Request LS Update LS ACK Total
Recd: 500 10 20 50 20 600
Sent: 400 8 16 40 16 480
Parameter Description
OSPFv2 Packet
Statistics
The number of packets of each type sent and received since
OSPF counters were last cleared.
LSAs Retransmitted The number of LSAs retransmitted by this router since OSPF
counters were last cleared.
LS Update Max
Receive Rate
The maximum rate of LS Update packets received during any
5-second interval since OSPF counters were last cleared. The
rate is in packets per second.
LS Update Max
Send Rate
The maximum rate of LS Update packets transmitted during
any 5-second interval since OSPF counters were last cleared.
The rate is in packets per second.
Number of LSAs
Received
The number of LSAs of each type received since OSPF
counters were last cleared.
OSPFv2 Queue
Statistics
For each OSPFv2 message queue, the current count, the high
water mark, the number of packets that failed to be enqueued,
and the queue limit. The high water marks are not cleared when
OSPF counters are cleared.