CLI Guide

Layer 3 Routing Commands 1832
IPv6 Policy-Based Routing
Commands
Dell EMC Networking N3000E/N3100E-ON Series Switches
Use IPv6 Policy-Based Routing commands to configure and view policy-based
routing for IPv6.
ipv6 policy route-map
Use this command to identify a route map to use for policy-based IPv6
routing on an interface.
Syntax
ipv6 policy route-map route-map-name
no ipv6 policy route-map route-map-name
• route-map-name —The name of the route map to use for policy-based
routing. It must match a route map tag specified by the route-map
command
Default Configuration
There are no route maps configured by default.
Command Mode
Interface (VLAN) Configuration mode.
User Guidelines
Policy-based routing must be configured on the VLAN interface that receives
the packets, not on the VLAN interface from which the packets are sent.
Packets matching a deny route map are routed using the routing table. Policy
maps with no set clause are ignored.
When a route-map applied on an interface is changed, i.e. new statements are
added to route-map or match or set terms are added/removed from the route
map statement, or if any route-map that is applied on an interface is removed,