CLI Guide

Dell EMC Networking CLI 185
IPv6 Multicast
show ip pim neighbor
Displays PIM neighbors discovered by PIMv2
Hello messages. If no interface is specified, the
command displays the neighbors discovered on
all PIM-enabled interfaces.
UE or
PE
show ip pim rp-hash
Displays the rendezvous point (RP) selected for
the specified group address.
UE or
PE
show ip pim rp mapping
Displays the mappings for the PIM group to the
active rendezvous points (RPs).
UE or
PE
show ip pim statistics
Displays the count of PIM sparse mode received
control packets per VLAN.
PE or
GC
a. For the meaning of each Mode abbreviation, see
Mode Types
.
Command Description Mode
a
clear ipv6 mroute
Selectively clears dynamic IPv6 multicast
entries from the cache.
PE
ipv6 pim (VLAN Interface
config)
Administratively enables PIM-SM multicast
routing mode on a particular IPv6 router
interface.
IC
ipv6 pim bsr-border
Prevents bootstrap router (BSR) messages from
being sent or received through an interface.
IC
ipv6 pim bsr-candidate
Configures the router to announce its
candidacy as a bootstrap router (BSR).
GC
ipv6 pim dense-mode
Administratively configures PIM dense mode
for IPv6 multicast routing.
GC
ipv6 pim dr-priority
Sets the priority value for which a router is
elected as the designated router (DR).
IC
ipv6 pim hello-interval
Administratively configures the PIM-SM Hello
Interval for the specified interface.
IC
ipv6 pim join-prune-interval
Administratively configures the interface
join/prune interval for the PIM-SM router.
IC
ipv6 pim register-threshold
Configures the Register Threshold rate for the
RP router to switch to the shortest path.
GC
Command Description Mode
a